![]() Another reason may be that if you are trying to get 120Hz on your gaming TV from your PC or. In this case, make sure that the input source on. I had an Onkyo that worked fine with this PC. As I was switching everything around, it worked every once in a while and then wouldnt work again. I have tried multiple HDMI cables, different HDMI port on the receiver, etc. Either it’s not plugged in or it is that old that it is simply beginning to malfunction. re facing no signal error on your PC, it could be due to the monitor ignoring the graphics output from your PC. I am having exactly the same problem hooking a PC to a brand new Denon AVR-S750H receiver. On pretty rare occasions, your HDMI cable may be at fault. I attempted to download GK41 drivers (from a post in this forum titled The GK 41 system and driver, however when attempting to unzip that (WinZip) it says it is not a valid. Whether you are playing in 60 Hz or 244 Hz, once in a while, your monitor may just lose signal randomly. And, as a test, I reconnected the old PC, and it continues to work.Īny suggestions from you would be appreciated. I can get the display working if I either (a) reboot the PC, (b) change resolution for display (via a remote access app), or (c) disconnect andĪs I mentioned, this setup WAS working perfectly with my old setup. 6 Troubleshooting Tips When Your PC Monitor Has No. The problem I'm encountering is when turning on the TV (which in turn powers on the AVR), no signal from the PC is received. Simple Fix for NO SIGNAL Message: How to Use a TV With Broken HDMI Ports : 11 Steps - Instructables. ![]() * PC is always on, and all sleep/standby functionality is turned off (NEVER sleep or standby) If this doesnt work, the next step is making sure the HDMI port is working properly. Step 3: Scroll to the Multiple displays section and tap the Detect button. Switch to the correct HDMI input, and the signal problem should be resolved. On the TV is says that there is no signal (I believe I am on the correct HDMI. ![]() Step 2: On the left-hand pane, select Display. PC DP out port -> DP to HDMI cable -> Monitor HDMI in port You are using. The HP monitors dont have HDMI inputs, only VGA, DP, and DVI-D. ![]() * When I turn on/off the TV, the AVR powers on/off in synch. Step 1: Launch the Windows Settings Menu and select System. I have two HPE241i monitors (which will do 1920x1200) as well as the P50 display (which will do 1920x1080). * AVR HDMI Main Out to TV HDMI 2 (ARC, with CEC turned on) I purchased the GK41 to replace the PC I've been using on my home theater setup (which involves the PC, an AVR, and an HD TV).Īll connections are exactly the same as they were on my old setup - which worked perfectly. ![]()
0 Comments
Leave a Reply. |